2026-08-07T02:47:12Zhttps://www.radar-service.eu/oai/OAIHandler

10.35097/q33qmram9mwszmc92026-05-08T14:30:36Zradar4kit

10.35097/q33qmram9mwszmc9 Bandaru, Nithin Kumar Nithin Kumar Bandaru 0009-0006-1039-7840 Karlsruhe Institute of Technology Dienwiebel, Martin Martin Dienwiebel 0000-0001-7682-0441 Karlsruhe Institute of Technology Gumbsch , Peter Peter Gumbsch Karlsruhe Institute of Technology Wolf, Jan Jan Wolf University of Stuttgart Möhring , Hans-Christian Hans-Christian Möhring University of Stuttgart Bandaru, Nithin Kumar,Dienwiebel, Martin 2025 2026 Materials Science Multilayer coatings TiN/AlTiN Tool wear Dry sliding experimental data Open Access Creative Commons Attribution Non Commercial 4.0 International Karlsruhe Institute of Technology https://ror.org/04t3en479 Bandaru, Nithin Kumar 0009-0006-1039-7840 Dienwiebel, Martin 0000-0001-7682-0441 Dienwiebel, Martin 0000-0001-7682-0441 Karlsruhe Institute of Technology Bandaru, Nithin Kumar 0009-0006-1039-7840 Karlsruhe Institute of Technology The mechanisms governing wear evolution in multilayer hard coatings remain a key challenge in tool tribology and dry machining. This study investigates the dry sliding behaviour of TiN/AlTiN multilayer-coated (thickness 1 μm/5 μm) as well as uncoated tungsten carbide (WC) cutting tools in a pin-on-disk configuration. Sliding tests were performed in a cylinder-on-line contact using commercial grooving inserts against AISI 1045 steel disks across a load–velocity matrix (20, 30 N; 10, 40, 80 m/min), with extended duration runs at 40 m/min to capture wear progression. The TiN/AlTiN-coated tools exhibited more stable friction coefficients and significantly reduced wear volumes compared to uncoated tools (73–92% lower specific wear rates, corresponding to 4×–12× improvement). The enhanced performance is attributed to the formation of a dense, oxide-rich tribofilm that effectively suppressed both adhesive and abrasive wear. In contrast, uncoated tools exhibited unstable frictional behaviour and severe material loss due to grooving and transfer. Wear evolution analysis using SEM/EDS, FIB cross-sectioning, WLI, and XPS depth profiling indicated gradual layer-by-layer wear progression in the TiN/AlTiN coating system, while uncoated tools showed accelerated nonlinear wear at higher velocities. The quantified wear coefficients together with the tribofilm chemistry provide mechanistic insight into coating wear and define key experimental inputs for future, physics-based tool-life modelling under dry machining conditions. This dataset contains experimental data from cylinder-on-flat pin-on-disc tribometer tests used to characterise and model the wear behaviour of PVD-coated WC-Co cutting tools (TiN/AlTiN/WC multilayer) sliding against C45 steel. Tribometer Optical Microscope Keyence Polytec TopMap Micro. View + XPS-ULVAC-PHI 5000 VersaProbe II en 323,5 MB application/x-tar